Using Pppoe; Not Using Pppoe - Siemens 5881 User Manual

SIEMENS 5881 Broadband Internet Router
User's Guide

Using PPPoE

If you will use the Point-to-Point Protocol (PPP) to establish the connection., you selected Using PPPoE.
Perform the following steps to complete setting up the router.
1. Enter the User Name and Password, which are used for authentication when the PPP connection is being
established.
2. In Service Name, enter the domain name of your network service provider. Use * as a default (for all
services).
3. In PPPoE Timer, enter the number of seconds of inactivity that must elapse before the PPP connection
closes. This helps to limit connection charges from your service provider during times of inactivity. The
default entry of "permanent" will keep the PPP connection open constantly, with no time out interval.
4. Optionally select NAT Enabled to enable Network Address Translation (NAT). NAT allows multiple
workstations on your LAN to share a single, public IP address. All outgoing traffic appears to originate from
the router's IP address.
5. Click Next. This displays the

Not Using PPPoE

If you will establish the connection based on IP addressing, you selected Not Using PPPoE. Perform the
following steps to complete setting up the router.
1. IP Routing routes all IP packets for remote hosts to the WAN. Specify how to obtain an IP address and
subnet mask by selecting one of the following:
•
Obtain configuration automatically from Wan using DHCP to have an IP address assigned
automatically using DHCP.
•
Configure IP Routing manually to assign IP addresses manually. If you select this option, you must
specify an IP Address, Subnet Mask, and Default Gateway in the appropriate fields. Default Gateway
assigns the IP address of the next-hop device.
2. Optionally select NAT Enabled to enable Network Address Translation (NAT). NAT allows multiple
workstations on your LAN to share a single, public IP address. All outgoing traffic appears to originate from
the router's IP address.
3. Click Next. This displays the
SIEMENS
Dynamic Host Configuration Protocol
Dynamic Host Configuration Protocol
Chapter 3 Easy Setup
page.
page.
Select Protocol
18