Fcc Class B Compliance Statement - Siemens S7 User Manual

Colour monitor S7
No display (power indicator lights)
Ê
Check whether the computer is switched on.
Ê
Check whether the data cable for the monitor is correctly attached to the monitor port on the
computer.
Ê
Press any key on the computer keyboard – the computer may be in energy saving mode.
Ê
Alter the brightness and/or contrast until you get a picture.
Picture disturbances (vertical and horizontal lines, picture noise)
First carry out the AUTO function.
Ê
If necessary, then adjust the picture definition with the PHASE function.
If one of the operating systems Windows for Workgroups, Windows 95/98, Windows NT,
i
Windows Me, Windows 2000, Windows XP or OS/2 with Windows emulation installed is
used, the basic monitor settings can be set with the floppy disk supplied.
Permanently unlit or lit pixels
The standard of production techniques today cannot guarantee an absolutely fault-free screen
display. A few isolated constant lit or unlit pixels may be present. The maximum permitted number
of pixels faults is stipulated in the stringent international standard ISO 13406-2 (Class II).
Example: a 17" flat-screen monitor with a resolution of 1280 x 1024 has 1280 x 1024 = 1310720
pixels. Each pixel consists of three sub pixels (red, green and blue), so there are about 4 million
dots in total.
According to ISO 13406-2 (Class II), a maximum of 6 pixels and 7 sub pixels may be defective, i. e.
a total of 25 faulted dots. This corresponds to approx. 0,002 % of the entire screen surface!
The flat screen monitors from Fujitsu Siemens Computers are typically considerably better than
requirements defined in this standard.
The screen becomes darker
The background lighting has a limited lifetime. If your monitor display should become too dark, the
background lighting will have to be exchanged. Please contact our Help Desk.

FCC Class B Compliance Statement

The following statement applies to the products covered in this manual, unless otherwise specified
herein. The statement for other products will appear in the accompanying documentation.
NOTE:
This equipment has been tested and found to comply with the limits for a "Class B" digital device,
pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian Interference-
Causing Equipment Regulations. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in strict accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
18 - English
A26361-K877-Z100-4-5E19