Loading Batteries; Turning The Tool On; Choosing The Settings; Setting Automatic Turn Off - DeWalt DW0165 User Manual

Hide thumbs Also See for DW0165:
Table of Contents

Advertisement

Available languages

Available languages

- Consult the dealer or an experienced radio/TV
technician for help.
Canada, Industry Canada (IC) Notices
Class B digital circuitry of this device complies with
Canadian ICES-003. This device complies with
Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2)
this device must accept any interference, including
interference that may cause undesired operation of
the device.
Under Industry Canada regulations, the radio
transmitter(s) in this device may only operate using
an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.)
is not more than that necessary for successful
communication.
Battery Safety
WARNING: Batteries can explode or leak
and cause serious injury or fire. To reduce the
risk:
ALWAYS follow all instructions and warnings
on the battery label and package.
DO NOT short any battery terminals.
DO NOT charge alkaline batteries.
DO NOT mix old and new batteries. Replace
all of them at the same time with new
batteries of the same brand and type.
DO NOT mix battery chemistries.
DO NOT dispose of batteries in fire.
ALWAYS keep batteries out of reach of
children.
ALWAYS remove batteries if the device will
not be used for several months.
NOTE: Ensure that the recommended
batteries are used.
NOTE: Ensure the batteries are inserted in
the correct manner, with the correct polarity.

Loading Batteries

1.
Pull up the endpiece on the back of the tool
(Figure
).
D 1
2.
Pull up the battery compartment latch on the back
of the tool (Figure
D 2
3.
Insert three AAA batteries, making sure to position
the - and + ends of each battery as noted inside
the battery compartment (Figure
4.
Push the battery door down until it snaps in place
(Figure
).
D 5
When the tool is ON, the battery level appears on the
screen (Figure
).
C 1

Turning the Tool On

1.
Point the tool's laser (Figure
or object, and not toward anyone's eyes.
2.
Press
(Figure
and display the red laser dot.

Choosing the Settings

Setting Automatic Turn Off

By default, the tool will automatically turn off
90 seconds after no buttons or options have been
selected. To change when the tool automatically turns
off, follow these steps.
1.
On the first screen (Figure
display the Main Menu.
2.
On the Main Menu (Figure
press
.
3.
On the Settings Menu (Figure
press
.
4.
Select the time.
• Choose to turn off the tool after 30 sec, 60 secs,
90 secs, or 300 secs.
• To keep the tool turned on until you manually
turn it off (by pressing and holding
10 seconds), select
5.
Press
to save your setting.
and
).
D 3
).
D 4
) toward a wall
A 1
) to turn the tool on
A 3
), press
E 1
), select
and
E 2
), select
and
G
for
.
E
to
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dw0330sDw0165s

Table of Contents