Power Supply And Ethernet - Siemens SCALANCE W788C-2 Operating Instructions Manual

Connection

5.2 Power supply and Ethernet

This equipment is suitable for use in Class I, Zone 2, Group IIC or non-hazardous locations
only.
5.2 Power supply and Ethernet
Connecting the power supply
Models RJ-45 / degree of protection IP30
The four-pin connecting socket has the following pin assignment:
Pin
1
2
3
4
The M12 socket for the power supply has the following pin assignment:
Pin
1
-
3
-
Power over Ethernet (PoE)
With the SCALANCE W7x8, power supply using Power over Ethernet (PoE) is also possible.
The devices support the standards 802.3at type 1 (IEEE 802.3af ) and IEEE 803.at type 2.
● Gigabit Ethernet
When you connect to gigabit Ethernet, the power supply is a phantom power supply over
data wires 1, 2, 3 and 6. This corresponds to alternative A according to IEEE 802.3af.
● Fast Ethernet
On an 8-wire Fast Ethernet cable, the power is supplied via the free data wires 4, 5, 7
and 8. This corresponds to alternative B according to IEEE 802.3af.
Note
Disabling the PoE power supply
Before you pull a plug via which the device is supplied with power using PoE, disable the
relevant PoE power supply.
22
Signal
L1+
M1
M2
L2+
Signal
L1
-
M1
-
Operating Instructions, 11/2014, A5E03692120-07
Description
24 VDC
Ground
Ground
24 VDC
Description
24 VDC
-
Ground
-
SCALANCE W788C-2