Table of Contents
Advertisement
SatelLink
Antenna Installation
Printed: 03.06.19,16:02
USER MANUAL
•
All Antenna Installation to be performed by Qualified Technical Personnel only.
•
Antenna Installation Instructions and locations below are for the purpose of
satisfying FCC RF Exposure Compliance requirements.
•
The In-Building Antenna connection is via a coaxial cable distribution system
with Signal Taps at various points connected to the fixed-mounted Indoor
Antennae. This is shown in the figure in the Introduction. The Indoor Antennae
are simple 1/4 Wavelength (0 dB Gain) types. They are used with KAVAL
WIRELESS TECHNOLOGIES 12, 16, or 20 dB Cable Taps. As such the
maximum EIRP will be at the first Tapped Antenna, which will be 12 dB below
the maximum signal level of the LSU (+40 dBm); +28 dBm, or 0.63 Watts EIRP.
If multiple LSU Modules are used with output combiners, then the
composite power output of all Modules transmitting simultaneously must
meet this maximum EIRP requirement. Please consult Kaval Wireless for
assistance as required. These Antennae are to be installed such that no person
can touch the Antenna, or approach within 0.2 Meters.
ALL ANTENNA INSTALLATION IS TO BE PERFORMED BY QUALIFIED
TECHNICAL PERSONNEL ONLY.
ANTENNA INSTALLATION INSTRUCTIONS AND LOCATIONS ARE FOR THE
PURPOSE OF SATISFYING FCC RF EXPOSURE COMPLIANCE
REQUIREMENTS, AND ARE NOT OPTIONAL.
ALL IN-BUILDING ANTENNAE INSTALLATIONS MUST BE SUCH THAT NO
PERSON CAN TOUCH THE ANTENNAE, OR APPROACH CLOSER THAN 0.2
METERS.
ANTENNA INSTALLATION
WARNING
Revision Date:6/19/03
DCM000000052
15
Advertisement
Table of Contents
