Table of Contents
Advertisement
SatelLink
Operation
Normal Operation
The LSU Head-End Module has one LED on the faceplate:
The LSU Remote Module has three LED's on the faceplate:
Configuration
It is possible to re-configure the LNKFIB-R01 Remote Module in the field, either
with a Personal Computer (PC) or via the optional LinkNet Control Module. To
use a PC it is necessary to connect the DB9 RS-232 connector on the Module to a
standard DB9 RS232 Connector on the PC. On the PC a terminal emulation
program such as HyperTerminal is used to communicate to the LinkNet Module.
The settings are 9600 baud, 8 bits, no parity, and 1 stop bit. Commands are one or
two words followed by pressing Return. Commands may be given in upper or lower-
case. Available commands are...
ACCESS USER:
HELP or ?:
LIST:
VER:
ENABLE 1 or 0:
GAINPCS ###:
GAINCELL ###:
GAINPAGE ###:
Please consult Kaval Wireless Technologies for further support.
Printed: 03.06.19,16:02
USER MANUAL
1. OPERATING - Normally this LED will be GREEN.
1. OPERATING - Normally this LED will be GREEN.
2. FAULT – Red LED, If the internal diagnostics for the module detect a
problem, then this LED will remain on
3. LASERS ON - This LED will be GREEN when any one of the three Lasers
are operating.
Required as a simple password to gain access to customer
settable parameters and diagnostics; This will time-out after 10
minutes, and may have to be re-typed.
Displays a list of Available Commands.
Displays Current Settings and Status Faults, Etc.
Display the current Version of Software.
Enables or Disables the Module.
Displays or Sets the PCS Transmit Gain (in tenths of a dB).
Displays or Sets the Cellular Transmit Gain (in tenths of a dB).
Displays or Sets the iDEN and Paging Transmit Gain (in tenths of
a dB).
Revision Date:6/19/03
DCM000000052
13
Advertisement
Table of Contents
