Advertisement
DO-170
PARA. #
CONDITIONS
3.1.1
Ground Survival Low Tempera-
ture and Operating Low Tem-
perature
3.1.2
Ground Survival High Temper-
ature and Short-Time Operat-
ing High Temperature
Operating High Temperature
3.1.3
Altitude
3.1.4
Decompression
3.1.5
Overpressure
2.11 &
Temperature Variation – Pre-
3.2
amplifier
3.3
Humidity
3.5
Vibration
3.6
Magnetic Effect
3.7
Voltage Spike Conducted
3.8.1
Induced Signal Susceptibility*
3.9
Radiated rf Susceptibility*
3.10
Emission of rf Energy*
3.11
Final Distortion
3.12
Push-To-Talk Switch Life
Fire Retardance
*Tests performed at Radiometrics Midwest Corporation,
Lombard, IL
Tested to DO-160B
**Tests performed at Elite Electronic Engineering,
Downers Grove, IL
INFORMATION TO USERS
This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio frequency energy,
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. Howev-
er, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference
ENVIRONMENTAL QUALIFICATION FORM, TSO-C58a
DO-160C
PARA. #
DESCRIPTION OF TESTS
4.5.1
Microphone tested to Category D1
4.5.2
Microphone tested to Category D1
4.5.3
Microphone tested to Category D1
4.6.1
Microphone tested at altitude equivalent to
15,200 m (50,000 ft) = 11.6 kPa (116 mbar, 87
mm [3.42 in.] Hg)
4.6.2
Microphone tested at altitude equivalent to
15,200 m (50,000 ft)
4.6.3
Microphone tested at pressure = 170 kPa; equiv-
alent altitude = –15,000 ft
5.3
Microphone tested to Category B for two cycles.
6.3.1
Microphone tested to Category A for 2 cycles.
8.5
Microphone tested to Categories N, B, & M
(Table 8-1, Not on Vibration Isolators)**
15.3
Microphone tested to Equipment Class Z; no
magnetic properties
17.3
Microphone tested to Category A
19.3
Microphone tested to Category Z
20.5
Microphone tested to Category A
21.4
Microphone tested to Category Z
After all required environmental tests micro-
phone meets requirements of DO-170, 2.2
After all required environmental tests micro-
phone meets requirements of DO-170, Appendix
B, T-7 and 2.9
In accordance with FAR 25; 25.869(a)(4) and
Appendix F, Part I (a)(3)(b)***
***Tests performed at Gaynes Test Laboratories,
Chicago, IL
All other tests performed at Shure Brothers Inc.,
Evanston, IL
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the microphone and receiver.
Connect the microphone transmitter into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
4
Advertisement
