Shure SOUND ISOLATING SE210 User Manual

Sound Isolating™ Earphones
Combining Hi-Definition
MicroSpeakers and a stylish sound
isolating design to deliver full
range audio free from background
noise, the Shure SE210 is an
ideal portable listening device
upgrade. An included modular
cable and interchangeable Sound
Isolating™ sleeves provide a
comfortable, personalized fit.
The carrying case further
enhances the portability
of these lightweight
earphones.
©2006, Shure Incorporated
27EN3243 (Rev. 2)
Grasp the body of earphone and gently twist to remove.
Note: Do not pull on cable to remove earphone.
SE210
Three suggested methods for wearing the earphones are
illustrated below.
Over the ear
in back
Tighten the cable and take up slack by raising the cable sleeve.
Printed in U.S.A.
Your earphones come with a selection of sleeves. Make sure the sleeve
you choose is easy to insert into your ear, fits comfortably, and is easy
to remove from your ear.
Soft Flex Sleeves
In small, medium, and large sizes.
Made from pliable rubber.
Soft Foam Sleeves
When using the foam sleeves, compress the sleeve
between your fingers before inserting it into the ear canal.
Hold the earphone in place for about ten seconds while the
foam expands and creates a tight seal.
Triple-Flange Sleeves
If desired, the sleeve stem may be shortened. Use sharp
scissors to carefully trim the stem to the desired length.
Note: carefully slide sleeve over earphone nozzle barb for a secure grip.
Cable
Over the ear
Sleeve
in front
Straight down
in front
If the earphone seems to be lacking in low frequency response (bass),
check the tightness of the seal between the earphone and your ear, or
try one of the other sleeve options.
Warning: Do not push the earphone sleeve beyond the ear canal opening.
To replace sleeve, carefully remove old one and slide new sleeve over nozzle
barb. If any part of the nozzle is exposed, sleeve is not properly installed.
Replace sleeves if they do not grip the nozzle tightly
Nozzle Barb
Sleeve Sleeve Over Barb
If you notice a change in sound quality, remove the sleeve and check
the nozzle of your earphone. If nozzle is blocked, clear obstruction by
using wire loop end of cleaning tool.
Wire Loop
Nozzle
Cleaning
Tool
When cleaning, do not force any object through the earphone
nozzle! This will damage the earphone sound filter.