Advertisement
SPECIFICATIONS
Battery Requirements
Capacity
Accuracy
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
1.
Use a clean, lint-free cloth to clean
the Anvil of the Micrometer and the
object being measured.
2.
Turn on. Choose inch or mm. To
switch from inches to millimeters,
hold the ABS-in/mm button for five
seconds to change from one to other.
Note. When the ABS-in/mm button is
pressed, the display automatically
resets to zero and takes
measurements from whatever the
previous position was.
3.
Rotating the Thimble
counterclockwise, open the Anvil
until it is wider than the object to be
measured.
Item 63647
Thimble Lock
Anvil
Set Button
3V (CR-2032) Lithium
Battery Included
0.00000 ~ 1.00000"
0.000mm ~25.000mm
0.001mm / 0.00005"
Resolution
0.004mm / 0.00015"
Indicated Error
For technical questions, please call 1-888-866-5797.
Display
On/Off/
Inch/mm Button
4.
Place the Anvil around the object and
turn the Thimble clockwise until the
Anvil just touches the object.
5.
Turn the Ratchet Stop clockwise to
close the Anvil on the object being
measured until it clicks. To avoid
damage to either the Micrometer
or the workpiece, only use the
Ratchet Stop to close the Anvil of the
Micrometer on the object.
6.
Turn the Thimble Lock clockwise to
lock the measurement and carefully
withdraw the Micrometer from the
object.
7.
This Micrometer measures items in
hundred thousandths of an Inch. View
the Display to see the results.
8.
To reset to zero, hold the ON/OFF/
SET button for five seconds.
Note. This is a delicate instrument. The
Micrometer should be handled
carefully. Drop ping this product could
damage it, and may effect accuracy.
9.
To prevent accidents, turn off the tool
after use. Clean, then store the tool
indoors out of children's reach.
Thimble
Ratchet
Stop
Page 3
Advertisement
