Configure the SL2100
SLNet Numbering Plan – F-Route
F-Route would typically be used to create a numbering plan that requires more than the first two digits to define
the SLNet node ID number.
F-Route allows for up to 8 or 24 digits to be defined, this guide will only use the 8 digit option.
F-Route also supports digit manipulation and alternate route selection, these options are not included in this
guide.
It is possible to use a mix of System Numbering and F-Route to setup your numbering plan.
It is recommended that you first confirm the numbering plan for all systems within the network
and allow for any potential future expansion
For example:
Node ID 5 has extension numbers 4100~4129
Node ID 6 has extension numbers 4130~4149
Within SLNet Numbering Plan – System Numbering define the leading digits as Type: F-Route Access.
Within F-Route - SLNet – Dial Analysis Table Lead Digits enter sufficient leading digits to be able to define the
SLNet Node ID number for all remote numbers.
Use a unique F-
Route table for each
remote node
Remote numbers
Quick Install Guide – SL2100 SLNet rev1.0
26