Chapter 2: Board Setup And Configuration; Electrostatic Discharge Caution; Board Component Location - Xilinx VCU128 User Manual

Board Setup and Configuration

Electrostatic Discharge Caution

CAUTION! ESD can damage electronic components when they are improperly handled, and can result
in total or intermittent failures. Always follow ESD-prevention procedures when removing and replacing
components.
To prevent ESD damage:
• Use an ESD wrist or ankle strap and ensure that it makes skin contact. Connect the equipment
end of the strap to an unpainted metal surface on the chassis.
• Avoid touching the adapter against your clothing. The wrist strap protects components from
ESD on the body only.
• Handle the adapter by its bracket or edges only. Avoid touching the printed circuit board or
the connectors.
• Put the adapter down only on an antistatic surface such as the bag supplied in your kit.
• If you are returning the adapter to Xilinx
immediately.

Board Component Location

The following figure shows the VCU128 board component locations. Each numbered component
shown in the figure is keyed to the table in
IMPORTANT! The board component locations figure is for visual reference only and might not reflect
the current revision of the board.
IMPORTANT! There could be multiple revisions of this board. The specific details concerning the
differences between revisions are not captured in this document. This document is not intended to be a
reference design guide and the information herein should not be used as such. Always refer to the
schematic, layout, and XDC files of the specific VCU128 version of interest for such details.
UG1302 (v1.0) December 21, 2018
VCU128 Board User Guide
® Product Support, place it back in its antistatic bag
Board Component Descriptions.
Send Feedback
Chapter 2
www.xilinx.com
9