Turning The Power Off (Putting The Projector Into Standby Mode); Image Projection; Switching The Input Mode - Sharp XV-Z3000U Operation Manual

Turning the Power off (Putting
the Projector into Standby Mode)
Press SSTANDBY/ON on the pro-
1
jector or aSTANDBY on the re-
mote control, then press that but-
ton again while the confirmation
message is displayed, to put the
projector into standby mode.
Unplug the power cord from the AC
2
outlet after the cooling fan stops.
• The power indicator on the projector
blinks in green while cooling.
• The power indicator changes to red when
the projector finishes cooling.
Info
• Do not unplug the power cord during projection
or cooling fan operation. This can cause dam-
age due to rise in internal temperature, as the
cooling fan also stops.

Image Projection

Switching the Input Mode

Select the appropriate input mode for
the connected equipment.
Press the appropriate INPUT button on
the remote control to select the desired
input mode.
• When pressing INPUT (P/R) on the projector,
input mode switches in the following order:
INPUT1 INPUT2
INPUT6 INPUT5
On-screen Display (confirmation message)
INPUT3
INPUT4
STANDBY
button
R
INPUT buttons
29