Table of Contents
Advertisement
Perform
configuration
!
Depending on how you configure the SINAUT MD740-1, you may then have to
adapt the network interface of the connected computer or network accordingly.
!
When entering IP addresses, always enter the IP address sub-numbers without
the leading zeros, e.g.: 192.168.0.8.
Please note:
In the following screenshots of the configuration pages of the SINAUT MD740-1 are
displayed. The caption of these screenshots refers to another product from SIEMENS
A&D. This product basically supports the same features as SINAUT MD740-1 (VPN,
Firewall) but has a different housing.
SINAUT MD740-1
To perform the configuration, proceed as follows:
1. Call up the
required setting
area via the menu.
2. Make the required
entries on the page
concerned.
3. Confirm with OK or
Apply, so that the
settings are
accepted by the
device.
If a page is not up to date when next displayed because the
browser is loading it from the cache, refresh the page display.
To do so, click on the Refresh icon in the browser's icon bar.
Configuration
23 von 105
Advertisement
Table of Contents
