Keystone Correction; Setting On-Screen Display; Selecting A Startup And Background Image; Eco/Quiet Mode Setting - Sharp Notevision XG-C335X Operation Manual

Using the "Options1" Menu
4 4

4 Keystone Correction

4 4
When the image is projected either from the top or from
the bottom towards the screen at an angle, the image be-
comes distorted trapezoidally. The function for correct-
ing trapezoidal distortion is called Keystone Correction.
Auto Keystone Correction
Set "Auto Keystone" on the "Options1" screen menu
to "On".
Manual Keystone Correction
Set "Auto Keystone" on the "Options1" screen menu to
"Off", and select "Keystone", then adjust with the slide bar.
Manual Correction
\ \ \ \ \ button
Note
• The Keystone Correction can be adjusted up to an
angle of approximately ±12 degrees with the "Auto
Keystone" and up to an angle of approximately ±40
degrees with the manual "Keystone".
(when "Resize" is set to "Normal")
• When the screen is slanting or the image is deterio-
rated, set "Auto Keystone" to "Off".
• When adjusting the keystone or when "Auto Keystone"
is set to "On", "Image Shift" is auto matically set to "0".
5

5 Setting On-screen Display

5
5 5
This function allows you to turn the on-screen
messages on or off.
Selectable items
On All On-screen Displays are displayed.
Off
• INPUT mode/VOLUME/AV MUTE/
FREEZE/AUTO SYNC/ENLARGE/
"An invalid button has been pressed."
are not displayed.
• "All buttons on Projector are locked."
is displayed when
pressed while the Keylock function is
active.
-48
| | | | | button
Description
STANDBY/ON is
Menu operation
6 6 Selecting a Startup and 6
6 6
Background Image
Selectable items
Logo SHARP default image
Blue Blue screen
None
Black screen
7

7 Eco/Quiet Mode Setting

7
7 7
Select-
Bright- Fan
able
ness Sound
items
On 80% Low
Off 100% Normal
Note
• When "Eco/Quiet Mode" is set to "On", the power
consumption will decrease and the lamp life will
extend. (Projection brightness decreases 20%.)
• You can also use ECO/QUIET button on the re-
mote control or on the projector to switch the Eco/
Quiet Mode. (See page 36.)

8 Auto Power Off Function

8 8
8 8
Selectable items
On The projector automatically enters the
standby mode when no input signal is
detected for 15 minutes or longer.
Off The Auto Power Off function will be
disabled.
Note
• When the Auto Power Off function is set to "On",
5 minutes before the projector enters the
standby mode, the message "Enter STANDBY
mode in X min." will appear on the screen to
indicate the remaining minutes.
Page 42
Description
Power
consumption
Lamp life
(When using
AC 110V)
300 W Approx.
3,000
hours
360 W Approx.
2,000
hours
Description