Sharp MD-MT821 Operation Manual page 32

3
While in the stop mode, press the
EDIT button to select "NAME STAMP".
4
Press the ENTER/SYNC button.
5
Press the ENTER/SYNC button.
ter MiniDisc is being read.
6
When the unit displays "CHANGE MD",
remove the master MiniDisc.
turning off the power. If you do, the
operation will be canceled.
7
Load the newly recorded MiniDisc into
the MD-MT821.
To cancel the operation, press the
8
Press the ENTER/SYNC button.
acter information and enter the stop
mode.
w r i t i n g ! 1
COMPLETE j
ter MiniDisc does not match the total
number of tracks on the newly recorded
MiniDisc, the unit will display "Can't
WRITE" and the power will be turned off.
If this happens, adjust the total number
of tracks on the newly recorded MiniDisc
using the edit operation, and then try
again from step 2.