Advertisement
Warning
● Changes or modifications to this unit not expressly ap-
proved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE:
G This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
z Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
z Consult the dealer or an experienced radio/TV technician for help.
The device must not be co-located or operating in con-
junction with any other antenna or transmitter.
2
To comply with FCC's and Industry Canada's RF radia-
tion exposure limits for general population/uncontrolled
exposure,this device must be installed to provide a sepa-
ration distance of at least 20cm from all persons."
This device complies with Part 15 of the FCC Rules. Op-
eration is subject to the following two conditions :
This device may not cause harmful interference, and
This device must accept any interference received, in-
cluding interference that may cause undesired operation.
Shielded cables must be used with this unit to ensure
compliance with the Class B FCC limits.
Advertisement
