Figure 82 Leveling The Unwinder - HP Indigo Division Series Instruction For Use & Installation Instructions

3. Position the unwinder so that the front surface of the unwinder is approximately 215 mm in
front of the front surface of the stepping plate assembly.
4. Align the center of the ILP rollers with the center of the unwinder rollers.

Figure 82 Leveling the unwinder

1 Leveler
2 Unwinder fixed roller
5. Place the level on top of a fixed roller at the position shown in Figure 82.
Use an M5 Allen key to raise or lower the leveling pads until the unwinder is
level to 0.0 ± 0.1 mm.
NOTE:
3 Unwinder
When leveling the unwinder, use the 2 mm spacers to
compensate for uneven floor height.
If a spacer cannot be inserted because the unwinder is too
low, use the jack to lift the low corner and insert the spacer.
CA294-03070 rev 00
Installation Manual
page 101 of 153