Connecting The Monitor To A Computer - Sharp LL-H1813 Operation Manual

Connecting the monitor and turning the monitor on and off

Connecting the monitor to a computer

Analog RGB connection
Connect the accessory analog signal cable or the
analog signal cable (sold separately-model name:
NL-C02E) to the DVI-I input terminal of the monitor
and analog RGB output terminal of the computer.
Analog signal cable
- Paying attention to connector direction, firmly
insert the signal cable to terminal, and then
tighten the screws at both sides.
If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal cable.
Macintosh conversion adapter
Digital RGB connection
Connect the digital signal cable (sold separately-
model name: NL-C01E) to the DVI-I input terminal
of the monitor and digital RGB output terminal of
the computer.
- For a digital signal input, it can be connected to a
computer with a DVI-compatible output terminal
(DVI-D24 pin or DVI-I29 pin) and which has
SXGA output ability. (Depending on the computer
to be connected, correct display may or may not
be possible.)
Input terminal 1 and 2
( You can connect to
either side )
Analog RGB output
terminal
Digital signal cable
- Paying attention to connector direction, firmly
insert the signal cable to terminal, and then
tighten the screws at both sides.
Set the monitor as follows when establishing a
digital connection with a Power Mac using an ADC-
DVI adapter made by Belkin. (Operation has been
checked with the Power Mac G4 M7627J/A)
- Perform settings with the Power Mac power
supply off.
1.After connecting the power cord, turn on the
monitor's main power.
2.Press the button and
and while doing this press the POWER button
(i.e. turn the power on).
3.Set the input terminal to which the Belkin ADC-
DVI adapter is connected to ON.
Use the SELECT button to select [INPUT1] or
[INPUT2], and use the
[ON] and [OFF].
- Do not set to [ON] if you are not using a Belkin
ADC-DVI adapter, as this may result in
incorrect display.
4.Press the MENU button.
This completes setting.
13
Input terminal 1 and 2
( You can connect to
either side )
Digital RGB output
terminal
button simultaneously,
buttons to select