Connecting The Tv To A Computer - Sharp LD-23SH1U Operation Manual

Connecting the TV to a computer

CAUTION!
- When connecting, ensure that the TV and all the
equipment you are connecting to it are switched
off.
- Be careful not to over bend the cable or add
extension cords as this could lead to a
malfunction.
Notes:
- When using the TV with an analog connection,
perform an automatic screen adjustment (page
E26) under the following conditions:
- Using the TV for the first time.
- After having changed the system settings
during use.
- When using the TV with a digital connection,
automatic screen adjustment is unnecessary.
- Depending on the computer or OS, you may
have to install the set-up information for the TV.
(See page E51.)
- When connecting to a notebook computer and
the notebook computer's screen is set so that it
is displaying at the same time, the MS-DOS
screen may not be able to display properly. In
this case, change the settings so that only the TV
is displaying.
Analog connection
Connect the supplied PC analog signal cable to
the analog RGB output terminal of the computer.
See page E10 for information on removing/
replacing the terminal cover.
PC analog RGB input terminal
(Mini D-sub 15 pin, 3 rows)
PC analog signal cable
(supplied)
- Paying attention to the connector direction, firmly
insert the signal cable straight into the
connector, and then tighten the screws at both
ends.
If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal
cable.
Power Macintosh
E20
Computer
Analog RGB output terminal
(Mini D-sub 15 pin, 3 rows)
Macintosh conversion adapter