Troubleshooting; Troubleshooting-Digital Broadcasting - Sharp Aquos LC-32GP1U Operation Manual

Appendix

Troubleshooting

Problem
• No power
• Unit cannot be operated.
• Remote control unit does not
operate.
• Picture is cut off/with sidebar
screen.
• Strange color, light color, or color
misalignment
• Power is suddenly turned off.
• No picture
• No sound

Troubleshooting-Digital broadcasting

The error message about reception of broadcast
The example of an error message
displayed on a screen
• Failed to receive broadcast.
• No broadcast now.
Cautions regarding use in high and low temperature environments
• When the unit is used in a low temperature space (e.g. room, offi ce), the picture may leave trails or appear slightly delayed.
This is not a malfunction, and the unit will recover when the temperature returns to normal.
• Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight or near a
heater, as this may cause the cabinet to deform and the Liquid Crystal panel to malfunction.
Storage temperature: f4°F to e140°F (f20°C to e60°C)
54
• Check if you pressed TV POWER on the remote control unit. (See page 17.) If the
indicator on the TV does not light up, press POWER on the TV.
• Is the AC cord disconnected? (See page 7.)
• Has the power been turned on? (See page 17.)
• External infl uences such as lightning, static electricity, may cause improper operation.
In this case, operate the unit after fi rst turning on the power of the TV or unplugging
the AC cord and replugging it in after 1 or 2 minutes.
• Is the FUNCTION set correctly? Set it to the TV setting position.
• Are batteries inserted with polarity (e, f) aligned? (See page 8.)
• Are batteries worn out? (Replace with new batteries.)
• Are you using it under strong or fl uorescent lighting?
• Is a fl uorescent light illuminated near the remote control sensor?
• Is the image position correct? (See page 35.)
• Are screen mode adjustments such as picture size made correctly? (See pages 37
and 38.)
• Adjust the picture tone. (See pages 27 and 28.)
• Is the room too bright? The picture may look dark in a room that is too bright.
• Check the input signal setting. (See page 40.)
• Is the sleep timer set? (See page 36.)
• Check the power control settings. (See page 30.)
• The unit's internal temperature has increased. Remove any objects blocking vent or
clean.
• Is connection to other components correct? (See pages 13 to 16.)
• Is correct input signal source selected after connection? (See page 31.)
• Is the correct input selected? (See pages 31 and 32.)
• Is picture adjustment correct? (See pages 27 and 28.)
• Is "On" selected in "Audio Only"? (See page 39.)
• Is a non-compatible signal being input? (See page 16.)
• Is the volume too low? (See page 20.)
• Is "Variable" selected in "Output Select"? (See page 39.)
• Have you pressed MUTE on the remote control unit? (See page 20.)
• Is "On" selected in "Subwoofer"? (See page 29.)
Error code
• Check the antenna cable. Check that the antenna is correctly
E202
setup.
E203 • Check the broadcast time in the program guide.
Possible Solution
Possible Solution