Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ABB ABB-free@home LS-1.1
Summary of Contents for ABB ABB-free@home LS-1.1
- Page 1 2CQA 100 001 B0001 │ 2018-09-28 Product Manual ABB-free@home™ LS-1.1 Light Switch...
-
Page 2: Table Of Contents
Table of Contents table of co ntent s The Device ............................3 Basic Operation ......................... 3 Advanced Operation ........................3 Adding the Light Switch ........................4 Configuring the Light Switch ........................7 Light Switch Settings ........................7 LED Settings ..........................8 Technical Data ............................. -
Page 3: The Device
The Device The Device The Light Switch is used to switch electrical loads ON and OFF. It can be integrated to the ABB- free@home™ Smart Home system allowing remote operation, i.e. by mobile devices (free@home System Access Point required). A binary input allows the connection of a mechanical switch in order to create a 3-way installation. -
Page 4: Adding The Light Switch
Adding the Light Switch Adding the Light Switch This section describes how to add the Light Switch to the system. STEP 1: Install the Light Switch Install the device by following the Operating Instructions included in the original packaging. Note: After installation, the Light Switch will immediately allow the lamp to function. To control the switch wirelessly, it will need to be added to the free@home network. - Page 5 Adding the Light Switch Start Go to Settings > free@home radio > Search for wireless devices The SysAP will now search for the Light Switch. Note: The Light Switch can only be found if the search starts within 30 minutes after the Light Switch was connected to power.
- Page 6 Adding the Light Switch Step 4: Add the Rocker Switch to the floor plan A. Click on “Sensors”. B. Drag the “Rocker” element into the floor plan. A new symbol will appear in the floor plan corresponding to the Rocker. Step 5: Connect the Light Switch to the Light A.
-
Page 7: Configuring The Light Switch
Configuring the Light Switch Configuring the Light Switch STEP 1: Lamp Settings Click on the lightbulb symbol to show the lamp settings. Define a name for this lamp. Light Switch Settings Setting Description Options Image This setting is only used in combination Autonomous with a motion detector. -
Page 8: Led Settings
Configuring the Light Switch LED Settings Setting Description Options Image LED switch-on User can adjust brightness night [%] brightness of LED LED switch-on User can adjust brightness day [%] brightness of LED · “Orientation light”: LED is always ON to find Light Switch at night Defines the reaction... -
Page 9: Technical Data
Technical Data 4 Technical Data Technical Data Description Value Operating Voltage 120 V AC, 60 Hz Operating Voltage Range 103 VAC to 121 VAC Connection L-wire and N-wire Required Binary Input Voltage 120 VAC Nominal Maximum Power Consumption < 1 W <... -
Page 10: Resetting The Device
Resetting the Device Resetting the Device Reset the Light Switch if it was previously assigned to a different System Access Point (SysAP). The reset will remove any previous connection and enable the device to connect to a new SysAP. Reset procedure: A) Press and hold the bottom of the rocker for at least 20 seconds. - Page 11 860 Ridge Lake Boulevard changes to the contents of this Memphis, TN 38120 document without prior notice. abb.com/freeathome The detailed specifications agreed upon apply for orders. ABB accepts no responsibility for possible errors Customer Service: or incompleteness in this 800-816-7809 document.