Connecting A Pc - Sharp LC-20SH21U Operation Manual

Connecting a PC

Viewing an Image from a PC
Use the INPUT 5 (PC) terminal to connect a PC.
• The PC input terminals are DDC1/2B-compatible.
• Refer to P. 21 for a list of PC signals compatible with the System.
• Make sure to select the same signal values for the output signal of a PC and the input signal of the LCD TV set before connecting with
the PC. (See P. 21)
• Depending on the PC being used, images may not be shown without converting the output signals into external output. Please refer to
your PC's manuals regarding converting to external output.
Signal names for 15-pin mini D-sub connecter
5
4 3 2 1
10 9 8 7 6
15 14 13 12 11
Displaying an Image from a PC
To AUDIO
input terminal
Connecting the RGB cable
P i n N o . S i g n a l n a m e
R
G
B
Not connected
CSYNC
• Pin No. 5 is not used for inputting the signal.
• Pin No. 9 is not connected with the supplied RGB cable.
To view an image from a PC, perform the following procedure.
Select the INPUT5 mode using INPUT on the remote control or the LCD TV set.
(See P. 16)
Select the PC input signal. (See P. 21)
Adjust the "Auto SYNC." items if the PC image does not come in clearly. (See P. 21)
To ANALOG To ANALOG RGB
RGB terminal output terminal
RGB cable
(commercially available)
ø 3.5 mm stereo minijack cable
(commercially available)
To Audio output
terminal
• Connect the RGB cable making sure
by tightening the screws on both
sides of the plug.
P i n N o . S i g n a l n a m e P i n N o .
GND (Ground)
GND (Ground)
GND (Ground)
+ 5V
GND (Ground)
PC
S i g n a l n a m e
Not connected
SDA
HD
VD
SCL
31