Supplied Accessories; Quick Reference; Attaching The Stand - Sharp LC 26SB27UT Operation Manual

Supplied accessories

Make sure the following accessories are provided with the product.
Remote control unit "AA" size battery
(X1)
Page 8
NOTE
• Always use the AC cord supplied with the TV.
To avoid scratching the frame or screen, please use a soft, lint free cloth for cleaning. Approved cleaning cloths are
available directly from Sharp in single (00Z-LCD-CLOTH) or triple (00Z-LCD- CLOTH- 3) packs. Call 1-800-BE-SHARP
for ordering, or VISIT www.sharpusa.com/SharpDirect.

QUICK REFERENCE

Attaching the stand

• Before attaching (or detaching) the stand, unplug the AC cord from the AC input terminal.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1
Confirm the 8 screws supplied with the TV.
Short screws (
(used in step 2)
2
Remove the covering sheet of the stand.
Attach the base to the post.
1
Attach the base to the 4 screws into the 4 holes on
2
the bottom of the base.
Hex key
Screw
Ventilation & Cleaning Tips
Keep your TV in a well ventilated area and make sure not to place it by a heat source or use near
water. The TV is designed for AC use only and should be used with supplied AC cord.
Clean the screen by spraying a soft lint free cloth with water to lightly moisten.
Gently wipe and avoid pressing on the screen. To clean the outer cabinet, use the same method.
Do not use liquid or aerosol cleaners.
6
The screen is glass and can be scratched or broken when dropped or impacted.
AC cord (X1)
(X2) Page 7
Page 8
4) Long screws (
X
(used in step 3)
Cable Tie (X1)
Page 7
3
Insert the stand into the openings on the bottom of
1
4)
X
the TV.
Insert and tighten the 4 screws into the 4 holes on the
2
rear of the TV.
4
For protection, sheets
are covering the product.
Please remove these
sheets before use.
NOTE
• To detach the stand, perform the step in reverse order.
LC-26SB27UT
Stand unit (X1) Operation manual
Page 6 (X1)
Hex key
Screw
Soft cushion