Watching Tv; Turning On/Off The Power; Initial Setup - Sharp Aquos LC 42SB45U Operation Manual

Watching TV

Turning On/Off the Power

POWER

Initial Setup

When you turn on the TV for the first time,
the Initial Setup will guide you through
the setup process. Perform the following
steps before you press POWER on the
remote control unit.
1.
Insert the batteries into the remote
control unit. (See page 13.)
2. Connect the antenna cable to the TV.
(See page 12.)
3. Plug in the AC cord to the AC outlet.
(See page 10.)
Press POWER on the TV, or POWER on the remote
control unit to turn the power on.
• POWER indicator (Blue): The TV is on.
Press POWER on the TV, or POWER on the remote
control unit again to turn the power off.
• The TV enters standby and the image on the screen
disappears.
• If you are not going to use this TV for a long period of time,
be sure to remove the AC cord from the AC outlet.
• Small amount of electric power is still consumed even when
the TV is turned off.
• If there is no signal input for 30 minutes, the power will turn to
standby mode automatically.
1. Initial Setup
•
2. Language setting
Select
•
Enter
•
The Initial Setup screen display at
the first use. Press Enter to start
the initial setup.
Initial Setup
Welcome to use the Wizard for
Initial Setup !!
Please press [ENTER] to start the
wizard.
Select the OSD menu language
from English, Spanish, or French.
a / b to select the desired
Press
language listed on the screen, and
then press the d button to the
next step.
Initial Setup
Please select your language:
Back Select Next
Welcome
Language
English
Español
Français
EXIT Exit
19