Other Viewing Options; Picture And Still Image; Presetting Remote Control Function - Sharp Aquos LC 37GB5U Operation Manual

Other viewing options

Picture and still image

You can display two same-sized pictures – one moving
and one still.
1
Press FREEZE.
• A moving image displays on the left screen and
a still image displays on the right screen. The
still image is one frame captured from a moving
image at the moment you press FREEZE.
2
Update the still image by pressing ENTER.
• Each time you press ENTER, the image on the
right screen updates.
3
Press FREEZE to exit still image.
NOTE
• This function does not work in INPUT 4 (HDMI) and INPUT
5 (DVI-I).
• When this function is not available, "No displaying still
image available." will display.
• The still image automatically goes out after 30 minutes.
• If you are using freeze function and a broadcast activates
the V-CHIP BLOCK, freeze function will be cancelled and
a V-CHIP BLOCK message will appear.
52

Presetting remote control function

You can operate the connected AV products (AV
Receiver, Cable Box, SAT tuner, DTV, VCR, DVD, LD)
using the presetting manufacturer function for your
remote control unit.
Presetting manufacturer codes
1
FREEZE
2
3
4
Press FUNCTION until the LED for your
device lights up.
After the LED for your device lights up, if you
press FUNCTION and DISPLAY and enter
the code registration mode, the LED will
blink.
Press 0 – 9 to enter the manufacturer code.
(See page 53.)
• Preset mode is finished once the LED no longer
lights up.
After registering the code, the LED will stop
blinking then turn off after one second. (If
you perform an incorrect operation, the LED
will blink quickly then turn off.)