Removing The Stand; Setting The Display On The Wall - Sharp Aquos LC 32GD6U Operation Manual

Preparation

Removing the stand

Before detaching (or attaching) stand, unplug the AC cord from the AC input terminal.
CAUTION
• Do not remove the stand from the Display unless using an optional wall mount bracket to mount it.
Before attaching/detaching stand
• Before performing work make sure to turn off the TV.
• Before performing work spread cushioning over the base area to lay the Display on. This will prevent it from
being damaged.
1
Unfasten the four screws used to secure the
stand in place.
CAUTION
• Do not remove the stand and speaker from the Display unless using an optional bracket to mount it.
NOTE
• To attach the stand, perform the above steps in reverse order.

Setting the Display on the wall

CAUTION
• Installing the Liquid Crystal Television requires special skill that should only be performed by qualified service
personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper
mounting or mounting that results in accident or injury.
Using an optional bracket to mount the Display
• You can ask a qualified service personnel about using an optional AN-37AG2 or AN-LCGWF bracket to
mount the Display to the wall. The AN-37AGZ is compatible with the LC-37GD6U and LC-32GD6U only.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-37AG2 wall mount bracket. (See the bracket instructions
for details.)
Vertical mounting
12
2
Detach the stand from the Display.
(Hold the stand so it will not drop from the edge of
the base area.)
About setting the Display angle
LC-37GD6U/LC-32GD6U
Angle of Display
With Speakers
Removed
LC-37GD6U 10˚
LC-32GD6U 20˚
With Speakers
Attached
10˚
20˚