Table of Contents
Advertisement
Basic adjustment settings
Power control
Power control setting allows you to save energy.
Power control for AV source
No signal off
When set to "Enable", the power will automatically shut
down if no signal inputs for 15 minutes.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Power Control".
3
Press a/b to select "No Signal Off", and
then press ENTER.
4
Press c/d to select "Enable", and then
press ENTER.
Enable
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• "Disable" is factory preset value.
• When a TV program finishes, this function may not operate.
No operation off
When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
1
Repeat steps 1 and 2 in No signal off.
2
Press a/b to select "No Operation Off", and
then press ENTER.
3
Press c/d to select "Enable", and then
press ENTER.
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• "Disable" is factory preset value.
Power control for PC source
Power control setting allows you to save energy.
Power management
When set, the power will automatically shut down.
1
Repeat steps 1 and 2 in No signal off.
2
Press a/b to select "Power Management",
and then press ENTER.
3
Press a/b to select "Mode1" or "Mode2",
and then press ENTER.
Selected item
Disable
Off
Mode1
Mode2
NOTE
• When using a digital PC and setting "Mode2" in Power
management, the power may not turn back on
automatically even if the signal inputs again.
• If you turn off the power by disconnecting AC cord when
setting "Mode2" in power management, the TV may not
function properly after turning the power on again. In such
case, press TV POWER on the remote control unit.
• Press POWER on the display will have the same result.
Off
Mode1
Mode2
Description
• No power management
• Factory preset value.
• If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the PC and the signal
inputs again, the TV stays off.
• The TV turns on again by pressing TV
POWER on the remote control unit. (See
page 20).
• Press POWER on the display will have the
same result.
• If no signal inputs for 8 seconds, the power
shuts down.
• When you start using the PC and the signal
inputs again, the TV turns on.
37
Advertisement
Chapters
Table of Contents
