Troubleshooting Chart - Sharp XL-DV60 Operation Manual

Troubleshooting chart

XL-DV60
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
" General
Symptom
! Did a power failure occur? Reset the clock.
The clock is not
set to the correct (Refer to page 21.)
time.
! Set the unit to the power stand-by mode and
When a button is
pressed, the unit then turn it back on.
does not re-
! If the unit still malfunctions, reset it. (Refer to
spond.
page 53.)
! Is the volume level set to "0"?
No sound is
heard.
! Are the headphones connected?
! Are the speaker wires disconnected?
! Is the TV or amplifier volume level set to "0"?
! Move the unit away from any computers or
Noise is heard
during playback. mobile phones.
! Is the unit unplugged?
The power is not
turned on.
" Remote control
Symptom
! Is the AC power cord of the unit plugged in?
The remote con-
trol does not op-
! Is the battery polarity correct?
erate.
! Are the batteries dead?
! Is the distance or angle incorrect?
! Does the remote control sensor receive
strong light?
52
Possible cause
Possible cause
" DVD player
Symptom Possible cause
! Is the TV turned on?
No images are
displayed.
! Is the input of TV switched?
! The video mode may not match the jacks you
are using. Change the mode as follows.
While in the stop mode, press the SHIFT but-
ton and DIRECT/VIDEO MODE button on
the remote control a few times (see page 17).
! Is the disc loaded upside down?
Even though a
disc is loaded,
! Is the disc very dirty?
"No Disc" is dis-
! Does the disc satisfy the standards?
played.
! Is the unit located near excessive vibrations?
! Is condensation formed inside the unit?
Playback sounds
are skipped.
! Is the disc very dirty?
The control but-
tons do not func-
! Does the disc satisfy the standards?
tion. Music or
! Is the unit located near excessive vibrations?
video playback is
! Is condensation formed inside the unit?
interrupted.
! Is the disc very dirty?
Pictures and
sound are
! Is the unit located near excessive vibrations?
skipped.
! Is condensation formed inside the unit?
! Is a disc other than a DVD (region number 1
The unit does not
operate even if or ALL), video CD, audio CD, CD-R or CD-
the power is on. RW loaded?
! Is a disc other than a DVD (region number 1
Images cannot
be played back. or ALL), video CD, audio CD, CD-R or CD-
(Sound is not RW loaded?
heard.)
! Is the disc very dirty?
! Is the disc loaded upside down?
! Is the optical pickup dirty?
! Is the TV input set to video (VIDEO1,
VIDEO2, etc.)?
! Is the unit turned on?