Enhancing Your System - Sharp XL-DV60 Operation Manual

Enhancing your system

The connection cord is not included. Purchase a commercially avail-
able cord as shown below.
White
Red
Optical digital cable
(commercially available)
" Listening to the playback sounds from VCR,
1
VCR, DVD, etc.
To the
2
line output
3
jacks
4
White
Red
Note:
To prevent noise interference, place the unit away from the televi-
sion.
" Digital connection to a surround amplifier or a
Audio cable
(commercially available)
Dolby Digital/DTS amplifier or
Digital audio recorder etc.
To the
optical line
input jack
" Headphones
! Before plugging in or unplugging the headphones, reduce the vol-
! Be sure your headphones have a 1/8" (3.5 mm) diameter plug
! Plugging in the headphones disconnects the speakers automati-
DVD, etc.
Use a connection cord to connect the VCR, DVD, etc. to the
VIDEO/AUX IN jacks.
When using video equipment, connect the audio output to this
unit and the video output to a television.
Press the ON/STAND-BY button to turn the power on.
Press the VIDEO/AUX button.
Play the connected equipment.
digital audio recorder, etc.
Selecting a sound signal type
When connecting other equipment to the digital audio output, ad-
just the audio output setting accordingly (see page 43).
BitStream
Choose this when connecting the unit to a Dolby Digital/DTS
(5.1ch) surround amplifier. When playing a DVD recorded in Dol-
by Digital or DTS, bitstream output allows you to enjoy the 5.1ch
surround sound.
LPCM
Choose this for PCM output. When playing a DVD recorded in Dol-
by Digital, the output converts to 2 channel PCM. When a DVD re-
corded in DTS is played back, signals are sent in bitstream.
ume.
and impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
cally. Adjust the volume using the VOLUME control.
XL-DV60
51