Troubleshooting - Bose CSP-428 Installation Manual

PRO.BOSE.COM

Troubleshooting

Problem
The Power LED on the front
panel is not lit solid green.
The power is on, but there
is no sound.
The sound is distorted.
The Power LED is red.
The Ethernet LED is off.
The Ethernet LED is
on but devices cannot
communicate with
processor.
Installation Guide • CSP-428/1248
What to do
Use the included power cord to connect the processor's power inlet (on the
rear panel) to a power outlet.
Make sure that the mains power is active.
Verify that there is an input signal from the source using the CSP configuration
utility. The audio input metering should be in the green/yellow band.
Verify that there is an output signal. The audio output signal metering should
be in the green/yellow band.
Check the audio input signal indicators using the CSP configuration utility.
If any of the audio input metering is in the red band, reduce the gain of the
audio input or the output volume of the audio device.
If the input and output indicators are green, and if you are sure the output
volume of the audio device is undistorted when it enters the processor, make
sure that the loudspeakers are not being overdriven or are not damaged.
Disconnect the power cord from the power outlet, and then reconnect it.
If the issue continues, call your Bose Professional sales/support representative.
Make sure that the processor's Network port is securely connected to a
computer, hub, or switch using a foiled or unshielded twisted-pair (F/UTP)
Cat 5e cable (not included).
Make sure that the computer's Ethernet connection is enabled. If it is
disabled, the Link LED on the computer will probably be off.
If the processor is connected to a hub or switch, make sure the Link LED on
the hub or switch is on.
If you recently connected the processor to a power outlet, wait 40 seconds
to make sure that the processor is fully turned on. The Power LED should be
solid green.
Make sure that the network settings on the TCP/IP Ethernet device you are
using on the computer are set correctly:
If you are not using a DHCP server, manually set the computer's IP
address to an unused IP address (e.g. 192.168.0.2).
The default IP subnet mask should be set to 255.255.255.0.
Open the firewall settings on the computer, and unblock all ports.
Make sure that there is not another processor connected with the same
address. If you are not sure, disconnect a processor, scan for the other
processor, and then change its address. Repeat with the second processor.
Maintenance
English • 19