Central Pneumatic 66801 Set Up And Operating Instructions Manual page 13

ImPOrtant: clean the spray gun ImmedIately after use.
Improper cleaning will cause the spray gun not to work.
a. Press the Red Button while spray-
ing. The Digital Display Screen will
display the units of air pressure.
b. Press the Red Button again to con-
vert the units between Bar and PSI.
c. The screen will continue to display
the air pressure for one minute, then
it will automatically shut off to save
battery power.
techniques
Incorrect
Correct (90
Figure 8
1. Keep the gun at a right angle to the
workpiece - See Figure 8. Pull the
Trigger (36) slowly and move the
Spray Gun in parallel strokes to the
object being painted. Keep the dis-
tance from the object being painted at
6" to 9". This may slightly differ de-
pending on the flow adjustment and
the material being sprayed.
For technical questions, please call 1-800-444-3353;
SKU 66801
(Heavier coat on
one side = uneven
coverage)
o
) (Even coverage)
troubleshooting section near the end of manual.
Begin
Squeeze
Stroke
Trigger
Figure 9
(Top View)
2. To avoid paint build up, start moving
the Spray Gun before you squeeze
the Trigger (36). When you are fin-
ished spraying, release the Trigger
before you stop moving the Spray
Gun. Doing so will eliminate distinct
overlaps, producing a blended (feath-
ered) affect - See Figure 9.
note: The speed of the stroke, the adjust-
ment of the Fluid Control Knob (12),
and the distance from the workpiece,
will determine how much paint is be-
ing applied. To get the best results,
try to apply two thin coats of paint
versus one thick coat.
3. To prevent accidents, turn off the
tool, detach the air supply, safely
discharge any residual air pressure in
the tool, and release the Trigger (36)
after use.
4. clean out the gun thoroughly im-
mediately after eVery use, ac-
cording to the instructions found
on the following pages.
End
Release
Stroke
Trigger
Page 13