Url of this page:
Sharp SPC900 Instruction Manual
Sharp radio controlled atomic thermo clock instruction manual.
Related Manuals for Sharp SPC900
No related manuals
Related Products for Sharp SPC900
Comments to this Manuals
Enter your comment:
Enter text from picture:
Write a comment
Jan 27, 2015 12:19:
Battery in clock went out. I replaced them everything is working except it is not reading outside temp.
Jan 12, 2015 03:39:
Lost remote sensor Where can I purchase one for SPC900
Dec 28, 2014 07:58:
A good clock. Easy to setup if you read the manual. Just replace batteries, press the reset button and allow it to find the temperature sending unit and find the atomic clock source. It takes a few minutes to find the clock source and the external temperature sending unit, it does configure itself after you set the time zone.
The time zone is set by pressing the time button and press the up/down buttons to find your time zone in the map display then press the time button again.
Dec 23, 2014 06:31:
One year later a piece of junk. Instruction to acquire some of the modes would confuseeven an engineer. Looking to return it to Bed, Bath & Beyond if I can find the receipt.
Nov 03, 2014 02:44:
I've had the clock for 6 years and it works perfect ... a real pain to reset time etc after changing batteries (not at all for those who are impatient) but beyond that its a good clock
Login to ManualsLib
Don't have an account? Sign up!
upload from disk
upload from url
Thank you for your help!