Signals From Nc Channel - Siemens SINUMERIK 808D ADVANCED Operating Instructions Manual

Detailed descriptions of interface signals
4.7 Channel-specific signals
4.7.2

Signals from NC channel

DB3300
DBX0.3
Edge evaluation: No
Signal state 1
Note for the reader
DB3300
DBX0.4
Edge evaluation: No
Signal state 1
Note for the reader
DB3300
DBX0.5
Edge evaluation: No
Signal state 1
Signal state 0
Application
corresponding to
...
Note for the reader Function Manual Basic Functions K1
DB3300
DBX0.6
Edge evaluation: No
366
Action block active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
Block search: Output of the collective auxiliary functions running.
Function Manual Basic Functions K1
Approach block active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
Block search with calculation / at contour: Approach block running
Function Manual Basic Functions K1
M0/M1 active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
The part program block is executed, the auxiliary functions are output, and
•
M0 is located in the work memory, or
•
M1 is in the work memory and IS "Activate M01" is active
The program status changes to stopped.
•
With IS "NC start"
•
For a program abort as a result of a reset
IS "Activate M01"
IS "M01 selected"
Last action block active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Parameter Manual