Table of Contents
Advertisement
Hardware Installation
1
2
3
4
5
6
7
8
Hardware Installation
The following sections describe how to install your camera:
•
•
Cisco Video Surveillance 8020 IP Camera Hardware Installation
To perform the hardware installation of the Cisco Video Surveillance 8020 IP Camera, follow these
steps:
Make a note of the MAC address of the camera.
Step 1
The MAC address is printed on the label that is attached to the camera.
Remove the dome cover by pressing the release button.
Step 2
Cisco Video Surveillance 8020/8030 IP Camera Reference Guide
1-4
IR LEDs
Motorized or fixed lens
SD/SDHC/SDXC card slot
Terminal block
Reset button
DI/DO wire inlet
Ethernet cable inlet
RJ45 Ethernet port
Cisco Video Surveillance 8020 IP Camera Hardware Installation, page 1-4
Cisco Video Surveillance 8030 IP Camera Hardware Installation, page 1-8
Chapter 1
Getting Started
Advertisement
Table of Contents
