Message - Tascam DR-70D Owner's Manual

Message

The following is a list of the pop-up messages.
Refer to this list if one of these pop-up messages appears on the DR-70D and you
want to check the meaning or determine a proper response.
Message Meaning and response
The batteries are almost out of power. Replace the
Battery Empty
batteries.
The SD card could not be recognized properly. Change the
Card Error
card.
The SD card has no remaining space. Erase unnecessary
Card Full
files or move them to a computer to make open space.
The total number of folders and files exceeds the limit of
File Full 5000. Erase unnecessary folders and files or move them to
a computer.
A file cannot be found or a file might be damaged. Please
File Not Found
check that file.
The system file is missing. This unit requires a system file
File Not Found
for operation. When this message appears, press the DATA
Make Sys File
dial to automatically create a system file.
File Protected The file is read only and cannot be erased.
The SD card is not formatted properly or the card is broken.
This message also appears if the card was formatted using
a computer connected by USB or if an unformatted card is
inserted in the unit.
Format Error
Format CARD Always use the DR-70D to format cards to be used with it.
Change the card or press the DATA dial while this message
is being shown to format the card.
Formatting will erase all the data on the SD card.
Invalid Card Something might be wrong with the SD card. Change the
Change Card SD card.
The system file required to operate this unit is invalid. When
Invalid SysFile
this message appears, press the DATA dial to automatically
Make Sys File
create a new system file.
Message Meaning and response
Folders can be created down to two layers. You cannot
Layer too Deep
create a new folder inside the current folder.
The SD card is not formatted properly or the card is broken.
Change the card or press the DATA dial while this message
MBR Error Init CARD
is being shown to format the card.
Formatting will erase all the data on the SD card.
No SD card is loaded in the unit. Insert a recordable SD
No Card
card.
There is no file that can be played back. The file might be
No PB File
damaged.
The audio file is not a supported format. Please see
Non-Supported "Connecting with a Computer" in the Reference Manual for
file formats that this unit can use.
Switched To Internal The power source has switched from USB bus power to
Battery the batteries in the unit.
Writing to the SD card timed out.
Write Timeout
Backup files on the card to a computer, and format the
card.
The setting cannot be changed.
Not Possible
Check INPUT3/4
Check the INPUT 3/4 setting.
The setting cannot be changed.
Not Possible
Check Rec Chs.
Check the recording channels.
The setting cannot be changed.
Not Possible
Set DUAL-REC OFF
Turn DUAL REC mode off.
No Rec Channels
No recording channels have been selected (all are off ).
Selected
If any other error occurs, turn the unit off and restart it.
19
TASCAM DR-70D