Sony CCU-TX7P Operating Instructions Manual page 11

3 SHUTTER setting section
SHUTTER
C.SCAN
ON
OFF
SHUTTER switch
SHUTTER switch: Use this switch to select a
shutter setting. This switch does not function
when the TLCS switch is on.
• C. SCAN: This activates the clear scan function.
• ON: This activates the normal shutter function.
• OFF: This turns off the shutter.
$ button and 4 button: When the SHUTTER
switch is set to either C. SCAN or ON, pressing
one of these buttons changes the shutter speed or
clear scan frequency as described below.
• When SHUTTER switch is set to C. SCAN
Pressing and holding one of these buttons
gradually reduces ($ button) or increases (4
button) the clear scan frequency.
• When SHUTTER switch is set to ON
Each time one of these buttons is pressed, the
shutter speed is reduced ($ button) or increased
(4 button) by one step.
If you press both of these buttons at once, it
resets the clear scan frequency or shutter speed
(depending on the SHUTTER switch's position)
to their factory settings.
Display: This displays the clear scan frequency
when the SHUTTER switch is set to C. SCAN or
the shutter speed when it is set to ON. "OFF" is
displayed here when the SHUTTER switch is set
to the OFF position.
When the TLCS switch is on, the display is blank.
Display
Hz
$ button and 4 button
4 WHITE/BLACK BALANCE control section
BLACK AUTO/
WHITE/BLACK switch and
MANUAL
indicators
switch
WHITE AUTO/PRE/MANUAL switch
WHITE/BLACK BALANCE
AUTO WHITE AUTO
PRE
MANUAL BLACK MANUAL
BLACK
BLACK knob
(red) BLACK knob
(blue)
BLACK AUTO/MANUAL switch
Use this switch to select whether to automatically
(AUTO) or manually (MANUAL) adjust the black
balance.
(When a DXC-637 series video camera is connected,
this switch is invalid and the black balance mode is
determined by the position of the WHITE AUTO/PRE/
MANUAL switch.)
WHITE/BLACK (white/black balance
adjustment) switch and indicators
When the WHITE AUTO/PRE/MANUAL switch is
set to AUTO, press this switch to the WHITE position
to automatically adjust the white balance.
When the BLACK AUTO/MANUAL switch is set to
AUTO, press this switch to the BLACK position to
automatically adjust the black balance.
The indicator by the WHITE or BLACK position
blinks at a one-second interval while the white balance
or black balance is being automatically adjusted. When
the automatic adjustment is completed, it stays lit for
about ten seconds, then goes out. If the automatic
adjustment fails, it blinks at a half-second interval for
about ten seconds and then goes out.
ATW button
ATW
WHITE
WHITE knob
(blue)
WHITE knob
(red)
11