Advertisement
IRONING CHART
NOTE:
Always refer to the garment care tag for ironing instructions. Before starting to
iron delicate fabrics, it is best to first test the temperature of the iron on a hem or an
inside seam.
DIRECTIONS
ON LABEL
SYNTHETIC
FIBERS, e.g.
acrylic, nylon
FABRIC
polyester
LED
DISPLAY
PANEL
STEAM
CONTROL
BURST OF
STEAM
SPRAY
SILK
COTTON
WOOL
LINEN
MIN
MAX
• • • • •
•
MINIMUM
MAXIMUM
0
STEAM
STEAM
9
TROUBLESHOOTING
PROBLEM
POSSIBLE REASONS & SOLUTIONS
• Iron should be plugged into a 120V AC electrical
outlet only.
Iron does not heat
Make sure that the plug is securely in the socket.
• Temperature setting too low.
Turn to higher setting.
• This is normal.
Some odor or small
Follow instructions for first use and allow iron to steam
particles come out of
through 2-3 fillings & press the steam burst button
steam vents of new
occasionally to eliminate small white particles.
iron
• Water tank may be empty or water level is very low.
Iron does not steam
Add water.
• Make sure that the fabric/temperature setting and
the variable steam control are correctly set. For
maximum steam, (setting 'Max' on steam control),
temperature setting should be set on '•••'.
• Variable steam control dial is set on "0".
Always allow the iron to reach the selected
temperature with the variable steam control setting
at '0'. Make sure the temperature setting is set in
the correct steam area, e.g. '•', and the steam control is
not on '0'. For more steam, turn temperature dial to
higher setting, e.g. '•••', and the steam control to 'Max'.
• If temperature setting and steam control setting are
correct and there is no steam, gently tap the
soleplate on the ironing board a few times. Move
the variable steam control from '0' to 'Max' a few
times.
• Iron may not be hot enough. Set temperature to the
Water droplets coming
'Max' position. Always allow iron sufficient time to
from steam vents
heat up before activating the variable steam control.
• Overuse of steam burst. Allow more time between
each burst.
• Iron may have been overfilled. Turn iron off,empty
water and follow instructions for filling.
• Steam performance may be low if iron requires
seasoning. To season, use regular tap water for 1or 2
tanks until steam performance improves.
10
Advertisement
