Description (Fi G. 1); Electrical Safety; Using An Extension Cable; Assembly And Adjustments - DeWalt DWP352VS Original Instructions Manual

ENGLISH
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Dust bag
b. Dust spout
c. Main handle
d. Front handle
e. Lock button
f. Trigger switch
g. Variable speed dial
h. Lever
i. Idler pulley
j. Date code
INTENDED USE
This heavy-duty belt sander has been designed
for professional sanding at various work sites (i.e.,
construction sites).
DO NOT use under wet conditions or in the
presence of flammable liquids or gases.
This heavy-duty belt sander is a professional
power tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is designed in class I (grounded)
E
according to EN60745. Earth wire is required.
WARNING: 115 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
24
If the supply cord is damaged, it must be replaced
by a specially prepared cord by the D
organisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
• Connect the yellow/green lead to the earth
terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.

Using an Extension Cable

If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm 2 ; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
WARNING: To reduce the risk of
serious personal injury, secure the
workpiece and maintain a firm grip
on the sander. Friction between the
sanding belt and the work will tend
to move the work backward and the
sander forward.
WARNING: To avoid severe abrasion,
ALWAYS keep fingers away from the
moving belt and areas where the belt
enters the housing.
WARNING: Severe laceration hazard.
If installed backwards, unidirectional
sanding belts may not track properly
and may overhang the housing,
possibly causing severe lacerations.
WALT service
E