Standards And Directives - Wolf WRS-K Installation And Operating Instructions Manual

3.1 Installation /
commissioning
3.2 Warnings
3.3 Service / repair
3.4 Disposal
4
3. Standards and directives
The components of the Wolf WRS-K control system comply with the following
regulations:
EC Directives
- 2006/95/EC Low Voltage Directive
- 2004/108/EC EMC Directive
EN Standards
- EN 55014-1 Emission
- EN 55014-2 Immunity
- EN 55022 Radio disturbance characteristics
- EN 55024 Immunity characteristics
- EN 60730-1 Automatic electrical controls for household and similar use
- EN 60730-2-9 Particular requirements for temperature sensing controls
- EN 61000-6-1 Immunity for residential, commercial and light-industrial
environments
- EN 61000-6-2 EMC Immunity for industrial environments
- EN 61000-6-3 EMC Emission standard for residential, commercial and light-
industrial environments
- EN 61000-6-4 Emission standard for industrial environments
- EN 61010-1 Safety requirements for electrical equipment for measurement,
control and laboratory use
- In accordance with EN 50110-1, installation and commissioning may only be
performed by qualified electricians
- Observe all regulations stipulated by your local power supply utility and all VDE or
local regulations
- DIN VDE 0100 Regulations regarding the installation of high voltage systems up to
1000 V
- DIN VDE 0105-100 Operation of electrical installations
Only operate the system in perfect technical condition. Immediately remove / remedy
any faults and damage that may impact on safety.
- Regularly check the perfect function of all electrical equipment.
Please note
- Only qualified personnel may remove faults or repair damage.
- Only replace faulty components or equipment with original Wolf spare parts.
We accept no liability for any damage or loss resulting from technical modifications
to Wolf control units.
Observe the following information regarding the disposal of faulty system
components or the system at the end of its service life: Dispose of all components
in accordance with applicable regulations, i.e. separate material groups correctly.
The aim should be the maximum possible recycling of basic materials with the least
environmental impact. Never throw electrical or electronic scrap into the household
waste, but recycle it appropriately.
Generally, dispose of materials in the most environmentally responsible manner
according to environmental, recycling and disposal standards.
3062941_201707