Table of Contents
Advertisement
G G e e t t t t i i n n g g S S t t a a r r t t e e d d
To charge the battery:
1. Plug the power cord of the desktop charger into a
standard AC outlet. When the power is connected
properly, the LEDs on the charger flicker briefly and
then turn off.
2. Place the battery into the compartment of the
charger. Select one of the following two options:
• Place the phone with the battery attached into
the front compartment. The left LED on the
charger glows red.
• Insert a battery alone, not attached to the phone,
into the rear compartment. The right LED on the
charger glows red.
18
3. The color indication of the LEDs on the charger is
as listed below:
• Red: the battery is being charged.
• Green: the battery is fully charged.
• Yellow: the battery is not plugged in correctly or
operating at a too high or too low temperature.
Please check the charger and/or battery.
4. When charging is completed (the LED turns into
green), remove the battery or phone from the
charger and unplug the power cord of the charger
from the AC outlet.
Low Battery Indicator
You can easily tell if your battery needs to be
recharged by checking the Battery Strength icon (
at the top right corner of your phone's display. The
presence of all three bars indicates a full charge, two
bars indicates a smaller charge, and one bar indicates
an even smaller charge. No bars (the battery icon is
empty) means that your battery need to be charged.
When the battery charge level gets low, the battery
sensor blinks an empty Battery Strength icon (
and sounds a beep. If the battery level gets too low,
the phone will turn off automatically. Unfortunately, if
this happens, you'll lose whatever you are doing and
your phone call will cut off. Watch the Battery
Strength icon and make sure your battery is
adequately charged.
G G e e t t t t i i n n g g S S t t a a r r t t e e d d
)
)
19
Advertisement
Table of Contents
