Maintenance; Cleaning - Serene HB80-2 User Manual

Glass door cooler
Table of Contents

Advertisement

SERENE HB80
3

Maintenance

8

Cleaning

To ensure the chiller continues to run efficiently and reliably, the following
routine maintenance should be carried out:
Cleaning Cabinet
Cleaning
Condenser Coil
Regular Servicing
Time Frames
Keep the interior and exterior of the cabinet clean
by regular wiping with a damp cloth, taking care to
keep moisture away from electrical parts. At the
same time check the condensation drain hole inside
the cabinet, to ensure proper drainage of any
condensation. Do not flush the cabinet with water.
Many commercially available cleaning products
contain solvents that may attack the plastic
components of this product and cause them to
crack. It is important to use only warm water and a
small amount of detergent when cleaning this
cabinet. Do not use abrasive or corrosive cleaners
or boiling water.
Clean the door gasket once every three months.
If an ice buildup occurs inside the cabinet, turn the
thermostat knob to '0' to switch the cooling system off
(the cabinet fan and lights will stay on). Once the
cabinet is defrosted turn the thermostat knob back to
the normal temperature setting (see page 7).
The condenser coil is located at the back of the
cabinet and should be cleaned at least every three
months with a soft brush to remove any dust build-
up (see instructions on page 9).
A thorough service clean must be completed by
qualified service personnel every six months.
Time frames specified above are indicative only.
More regular cleaning and servicing may be
required depending on cabinet placement and
operating environment.
Maintenance
User Manual

Advertisement

Table of Contents
loading

Table of Contents