Hitachi CP-DX250 Service Manual page 38

5. Remove the protection film. Loosen the screw that
secures the lamp. Refer to the right figure to identify the
screw.
6. Disconnect the lamp's wire connector from the
projector, and then slowly pick up the lamp by the
handle.
CAUTION
• Pulling it too quickly may cause the lamp to break
and scatter broken glass in the projector.
• Do not place the lamp in locations where water
might splash on it, children can reach it, or near
flammable materials.
• Do not insert your hands into the projector after the
lamp is removed. If you touch the optical
components inside, it could cause color
unevenness and distortion of the projected images.
7. Insert the new lamp into the lamp compartment and
make sure it fits in the projector. Connect the new
lamp's wire connector to the projector.
8. Tighten the screw that secures the lamp.
CAUTION
• Loose screw may cause a bad connection, which
could result in malfunction.
• Do not over tighten the screw.
9. Ensure the handle is fully laid flat and locked in place.
10. Replace the new protection film that comes with the
new lamp.
11. Replace the lamp door on the projector.
37