Axial And Radial Forces At The Second Shaft Extension; Complete The Installation Work - Siemens SIMOTICS HV C Operating And Installation Instructions

Assembly

5.4 Complete the installation work

5. Lower the machine completely onto the mating flange so that it is fully in contact; then
6. Fix the machine using the flange fixing bolts.
5.3.6

Axial and radial forces at the second shaft extension

Large output masses and their centers of gravity outside the shaft extensions can cause
vibration. This can result in damage to bearings, the shaft, or components in the shaft
assembly.
● Comply with permissible loads for the forces on the shaft extensions in accordance with
● If necessary, contact the Service Center.
See also
Service and Support (Page 111)
5.4 Complete the installation work
1. Check that all of the screw connections are correctly tightened.
2. Once you have completed the installation work, remove all objects – such as tools, cloths,
3. Clean the machine to remove any dirt that may have accumulated as a result of the
4. Protect all exposed rotating parts against contact by persons. Cover any open shaft ends,
5. Make sure that there are no loose parts on or in rotating machine elements. Observe any
Record all of the installation work that was carried out.
54
remove the studs.
the configuration data.
deposits of dirt and moisture, etc. – from the machine.
installation work.
couplings and belt drives, etc.
feather keys that may be located in free shaft ends.
SIMOTICS HV C 1NB1402-2AA84-4CA0-Z
Operating Instructions 06/2018