First Launch; Recommendations - Planar 2D-24 Installation Instructions Manual

4 First launch

After installation, carefully check if all wires, harnesses and
electric connections are well installed and fastened. Fill the fuel
line and vent out air.
The fuel line may be filled using two methods:
1) switch the heater on and off several times for
five minutes.
2) use a fuel priming device*.
The transparent fuel lines are used to monitor the filling of
the fuel line.
Supply power to the heater and install fuses on the power
wire harness.
During the first launch, check air tightness of all connection
and how securely they are fastened. Tighten the collars, if
necessary.
During the first launch, the exhaust pipe might emit some
smoke.
*—optional part.

5 Recommendations

If the heater does not start after switching on, make
sure there is fuel in the tank, check the charge of the battery,
check if connectors are properly connected and if the 25A
fuses are good.
If you were unable to find the root cause of the fault,
contact the service center, the dealer you bought the
product from or the website www.autoterm-europe.com.
.
31