Using The Cable Tie Set; Using The Lens Rubber Cap - BenQ LK970 Installation Manual

Using the cable tie set

The cable tie set helps prevent a cable plug from falling out of the connecting port. It contains the
following parts.
Cable tie ratchet
To use the cable tie set:
1. Firmly plug a cable to a correct port on the
projector. Insert the cable tie head to the
cable tie hole right above the connecting port.
Note that the cable tie cannot be removed
from the hole once it is inserted.
3. Insert the end of the cable tie to the cable tie
ratchet as illustrated.
4. Close the cable tie ratchet by pressing its tab.

Using the lens rubber cap

When the projector is installed or mounted in any way other than a horizontal position, use the rubber
cap to keep the zoom ring from rotating due to its own weight. After the focus and zoom rings are
adjusted, follow the illustrations to insert the rubber cap to keep them in position.
1
3
4
Cable tie
Cable tie head
2. Take the cable tie ratchet. Slightly open the
ratchet to surround the connecting cable.
5. Move the cable tie ratchet along with the
cable tie to the end of the cable plug.
The cable tie installation is done.
2
5
11