Writing Automatic Refresh Parameters - Mitsubishi Electric Melsec Q Series User Manual

6
PARAMETER SETTING

6.6.3 Writing Automatic Refresh Parameters

Write the automatic refresh parameters to the QCPU.
Reset the QCPU after writing the automatic refresh parameters.
(1) Start procedure
6
- 19 6.6 Automatic Refresh Parameters
6.6.3 Writing Automatic Refresh Parameters
1) Select "Download to Module" in "Task Panel".
2) Check that the "Update Autorefresh settings" checkbox is selected in the
"Select Items for Download" window.
Figure 6.11 "Select Items for Download" window
3) Click the
OK
QCPU.
POINT
Make sure to read automatic refresh settings on GX Works2 when the automatic
refresh parameters were written on GX Configurator-DP.
If the automatic refresh parameters were written before reading the settings on
GX Works2, the parameters are deleted on a master module or slave modules.
button. The automatic refresh parameters will be written to the