[Off] - Panasonic PT-VW360 Operating Instructions Manual

Adjusting the volume
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [VOLUME].
4) Press qw to adjust the level.
Operation
Press the w button.
Press the q button.
Adjusting the balance
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [BALANCE].
4) Press qw to adjust the level.
Operation
Press the w button.
Press the q button.
Setting the mute status
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [MUTE].
4) Press qw to switch the item.

[OFF]

[ON]
Setting the audio output during standby
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [IN STANDBY MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f When [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] or [NETWORK] (x page 77), even if [IN STANDBY MODE] is set to
[ON], audio cannot be output during standby.
f When the power is switched off at the digital signal input with [IN STANDBY MODE] set to [ON], the audio may be interrupted in the process
of the projector entering the standby mode.
Setting audio input selection
Choose the audio input terminal for each input signal.
Chapter 4 Settings - [PROJECTOR SETUP] menu
Adjustment
Increases the volume.
Decreases the volume.
Adjustment
Increase the volume of the right channel.
Increase the volume of the left channel.
Outputs the audio.
Turns off the volume temporarily.
Disables audio output in the standby mode.
Enables audio output in the standby mode. At this time, press the <VOL +> button / <VOL -> button on the
remote control or qw buttons on the control panel to adjust the volume.
Range
0 ~ 63
Range
L16 ~ R16
ENGLISH - 79