Table of Contents
Advertisement
Radio Reassembly — Detailed
6.6
Control Top Disassembly
1.
To remove the control top assembly, place a screwdriver next to the antenna boss, and pry it
against the control top escutcheon. This will lift the control top escutcheon away from its
double-sided adhesive. Grasp the double-sided adhesive near the volume potentiometer, and
lift it away.
2.
Remove the control top seal, emergency button, and transmit light pipe.
7.0
Radio Reassembly — Detailed
7.1
Control Top Reassembly
1.
Replace transmit light pipe and control top seal.
2.
Place a new control top escutcheon adhesive against the front cover. Press the control top
escutcheon tightly against the adhesive.
3.
Put the PTT seal in the PTT bezel.
7.2
PTT Reassembly
1.
Place the bezel top tab in the top slot inside the front cover PTT opening. Slightly bow the
bezel so that the bottom tab can fall inside the bottom slot.
2.
Press the PTT assembly against the front cover opening.
NOTE
Look inside the front cover to make sure the T-tab is fully engaged with the front cover. If
necessary, press the T-tab toward the top of the radio until it becomes fully engaged.
7.3
Speaker, Microphone, and Universal Connector Flex Reassembly
1.
Feed the universal connector tail of the speaker-microphone flex assembly through the open-
ing in the side wall of the front cover.
2.
Peel-off the adhesive liner on the back of the universal connector tail of the flex circuit. Attach
the flex tail to the front cover using the guide pins for correct alignment.
3.
Replace the universal connector escutcheon. Make sure that all the connector openings align
with the gold pads on the flex circuit.
4.
Align the notch in the speaker at the twelve o'clock position with the tab on the front cover.
(See Figure 3-8.)
5.
Place the speaker retainer bracket into the hole on the top of the front cover, and bend the
retainer down to fit underneath the boss below the speaker.
7.4
Keypad, Display, and Keypad Option Board Reassembly
1.
If you are replacing the display, use a new double-sided adhesive display pad (item number
17 [GP360/380] on the exploded view diagram).
2.
Replace the keypad, and the keypad/option board. Make sure the display module flex tail is
connected correctly to the connector on the keypad/option board.
3.
Insert the "top hooks" of the keypad retainer into the slots below the speaker (above the
display) in the front cover. Snap all of the retainer arm tabs in place in the front cover.
NOTE
Pull the speaker-microphone flex circuit out of harm's way during reassembly.
3-11
Hide quick links:
Advertisement
Table of Contents
