Solving Picture Problems - Seiko POWERLITE 8345 User Manual

Solving Picture Problems

You cannot turn on the projector.
■
Make sure the power cord is connected and the power switch in back of the projector is
turned on. Then wait a moment for the Ppower light to come on before pressing the
Ppower button.
■
If you've set the
use the remote control to turn on the projector (see page 32).
■
If you've set the
on the projector, or use the remote control (see page 32).
No picture appears on the screen or you see the
■
Press one of the
on the projector, to select the correct input source. Allow a few seconds for the projector
to sync up after pressing the button.
■
Press the
off temporarily.
■
Check that the Ppower light is on, the Ppower light is not flashing, and the lens cover is
off.
■
The projector may be in standby (sleep) mode. If the Ppower light is on and the
source light is off, press the Ppower button to turn the projector back on.
■
Make sure your video equipment is turned on.
■
Make sure your cable(s) are connected correctly (see page 18).
Only part of the picture is displayed, or the picture is distorted.
■
Press the
■
If the Aspect is set to
the top or bottom section of the screen so that subtitles are visible (see page 45).
■
Check the
■
Use the
Position
■
If you've connected a computer and you see only half the image, make sure the
computer's Dual Display setting is turned off. If part of the image is cut off, reset the
projector settings (see page 43).
58
Problem Solving
Control Panel Lock
, you have to press the Ppower button for 3 seconds to turn
Child Lock
buttons on the remote control, or press the
Source
button on the remote control to make sure the picture hasn't been turned
Blank
button to select a different aspect ratio (see page 27).
Aspect
, you may need to use the
Zoom
to make sure it's adjusted correctly (see page 44).
Overscan
setting to reposition the image on the screen (see page 44).
, the control panel buttons are disabled; you must
No Signal
Zoom Caption Pos.
message displayed.
source button
option to see