Inserting/Removing A Sim Card - Panasonic FZ-G1 Series Operating Instructions - Reference Manual

Wireless WAN
<Only for model with wireless WAN >
This computer is equipped with the Wireless WAN enabling you to communicate using radio frequencies.
N O T E
Communication is established through the Wireless WAN antenna (A). Do not block the antenna area with
n
your hand or body.
To use wireless WAN, set
n
[Advanced] menu of the Setup Utility.
Before the computer enters sleep or hibernation, cut the Wireless WAN communication. Entering sleep or
n
hibernation without cutting the connection may disable communication after resuming. In this case,
restart the computer.
If "Device driver software was not installed correctly." (or a similar message) appears when starting the
n
computer or resuming from sleep or hibernation.
When communication works normally, Wireless WAN is operating correctly.
If communication fails, the device may not be recognized correctly. In this case, restart the computer.

Inserting/Removing a SIM Card

Before using the Wireless WAN, set a SIM card to the SIM card slot.
C A U T I O N
Be sure to turn off the computer before inserting or removing the SIM card.
n
To insert a SIM card
1. Turn off the computer.
2. Disconnect the AC adaptor, remove the battery pack. (
3. <Only for model with Built-in Bridge Battery>
Wait for about 3 minutes.
4. Remove the screws (A) and the SIM card slot cover (B).
[Wireless WAN] of [Wireless Configuration] to [Enabled] (default) in the
Replacing the Battery Pack)